... | ... | @@ -12,6 +12,7 @@ the pinheader should only be soldered after the electrolytics and the fuses are |
|
|
the short standoff pinheaders erroneously use a metric spacing. just use the 5-pinheads and cut them into stripes of one and solder only a few as indicated in the detailed manual at step 53-54
|
|
|
- R3 is not needed, bridge it with a clipped resistor leg (step 37)
|
|
|
- C2 are on both the components and the panel PCB. To better discern between both of them, in the detailed build document they are labelled as C2 and C2POTS (step 26/45)
|
|
|
- C3 should be styroflex
|
|
|
|
|
|
## Mods
|
|
|
- the oscillators frequency range can be tuned using a different value for C3 (step 27)
|
... | ... | |