... | ... | @@ -10,7 +10,7 @@ the silkscreen print for 10k and 18k resistors looks very similar. make sure to |
|
|
the pinheader should only be soldered after the electrolytics and the fuses are soldered. boxed ones will hide the silkscreen indicating the red stripe which is at the edge of the PCB
|
|
|
- standoff pinheaders
|
|
|
the short standoff pinheaders erroneously use a metric spacing. just use the 5-pinheads and cut them into stripes of one and solder only a few as indicated in the detailed manual at step 53-54
|
|
|
- R3 is not needed, bridge it with a clipped resistor leg (step 37)
|
|
|
- R3 on the Pots PCB is not needed, bridge it with a clipped resistor leg (step 37)
|
|
|
- C2 are on both the components and the panel PCB. To better discern between both of them, in the detailed build document they are labelled as C2 and C2POTS (step 26/45)
|
|
|
- C3 should be styroflex or mica (it should be relatively accurate and stable regarding temperature changes).
|
|
|
|
... | ... | |