documentation.md

@@ -64,15 +64,15 @@ th 555 vco diy expo)
 45. solder C2POTS with 220nF
 46. Do not solder: push in the green pots (except PWM_CV)
 47. Do not solder: push in the Jacks
-48. Put the Panel onto Pots and Jacks. Screw it on with the fingers
-49. solder Pots and jacks (make sure everything sits tightly, before soldering the first things). Be careful not to apply too much solder at the jacks.
-50. Take of the panel again
-51. Split the two 5-pin headers (2x male and 2x female) into four 1 pieces. Use a cutter first and then split it with two pliers.
-52. stack both boards with the pinheaders inbetween and solder the pinheaders together (if you are not sure they are straight, only solder one pin)
-53. Solder the last potentiometer (the one with the plastic shaft)
+48. Do not solder: push in the pot with plastic shaft
+49. Put the Panel onto Pots and Jacks. Screw it on with the fingers
+50. solder Pots and jacks (make sure everything sits tightly, before soldering the first things). Be careful not to apply too much solder at the jacks.
+51. Take of the panel again
+52. Split the two 5-pin headers (2x male and 2x female) into four 1 pieces. Use a cutter first and then split it with two pliers.
+53. stack both boards with the pinheaders inbetween and solder the pinheaders together (if you are not sure they are straight, only solder one pin)
 54. Put the ICs into the sockets (watch for the orientation! you may have to bend the IC legs to make them fit)
 55. Put the Panel back on, screw everything into place
-56.
+56. Assemble the Powercable